Argo AES Series Instrukcja Obsługi Pobierz pdf (Strona 20)

20 A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Before the journey

Large storage spaces, such as the rear garage, also have room for heavy

objects (e.g. motorcycle). This might mean that the axle load on the rear axle

is exceeded.

However, the individual axles may not be overloaded under any circum-

stances. That is why it is important, at which distance to the axles the load is

stored.

To distribute the load correctly, you will need a scale, a tape measure, a cal-

culator and some time.

Two simple formulas are needed to calculate the effect of the weight of the

load on the axles:

Formulas A x G : R = weight on the rear axle

Weight on the rear axle – G = weight on the front axle

Explanation A = distance between storage compartment and front axle in cm

G = weight of the load in the storage compartment in kg

R = wheelbase of the vehicle (distance between axles) in cm

Calculating axle loads:

 Multiply the distance between storage compartment and front axle (A) with

the weight of the load in the storage compartment (G) and divide the result

by the wheelbase (R). The result is the weight of the load in the storage

compartment on the rear axle. Make a note of this weight and of the storage

compartment.

 In a second step, subtract the weight in the storage compartment (G) from

the weight calculated beforehand. If the result is a positive value

(example 1), this means that the load on the front axle is reduced by this

value. If the result is a negative value (example 2), this means that the load

on the front axle is increased. Make a note of this value, too.

 Calculate all storage compartments of the vehicle in the same way.

 In a last step, add all weights calculated for the rear axle to the rear axle

load and add (or subtract) all weights calculated for the front axle to (from)

the front axle load.

How to determine rear axle load and front axle load is described in

section 3.3.2.

X Distribute the load evenly on both axles. In doing so, observe the axle

loads specified in the vehicle documents. Observe the permissible load-

carrying capacity of the tyres (see chapter 13).

X Heavy loads behind the rear axle can reduce the load on the front axle

due to the leverage effect ( ). This applies especially to long rear

extensions, if a motorbike is transported on the rear carrier or if there is

a heavy load in the rear storage space. The release of the front axle neg-

atively affects the driving quality, especially for front-driven vehicles.

X Store all objects in such a way that they cannot slip.

X Store heavy objects (awning, tin cans, etc.) close to the axles. Low-lying

storage compartments whose doors do not open in the direction of travel

are particularly suited for storing heavy objects.

X Stack light objects (laundry) in the roof storage cabinets.

X Load the bike rack with bicycles only (max. three units).

Z Measure the external distances horizontally from the centre of the front

wheel to the centre of the storage compartment or to the centre of the back

wheel.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 261 262

Komentarze do niniejszej Instrukcji

Brak uwag

Argo AES Series Instrukcja Obsługi Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Argo AES Series